Abstract
To address the limitations of conventional lubrication under high-temperature and heavy-load conditions, (CrAlVTiNb)N high-entropy nitride coatings were deposited via high-power impulse magnetron sputtering (HiPIMS). This study systematically evaluates the coating's tribological performance and interfacial evolution across various lubricating media and mechanical loads. Structural characterization confirms the formation of a dense, single-phase face-centered cubic (FCC) solid solution, which exhibits a surface roughness of 5.48 nm. The coating exhibits a hardness of 32 GPa, an elastic modulus of 311 GPa, and a critical adhesion strength of 72 N. Tribological tests at 350 degrees C demonstrate that polyurea grease (PUG) significantly outperforms DIPE and CH51, achieving a stable ultra-low friction coefficient of 0.0065 and a wear rate of 2.16 & times; 10(-7) mm(3)/(N & sdot;m) under a 30 N load. This synergistic effect is robust within the 5-30 N load range; however, a 40 N load impairs the lubricating film's integrity. The superior tribological performance stems from tribochemically induced formation of an amorphous phosphate layer at the contact surface, whereas the underlying coating matrix retains a stable FCC crystal structure. This work investigates the (CrAlVTiNb)N/PUG solid-liquid composite lubrication behavior at 350 degrees C, and provides theoretical and technical insights for developing advanced lubrication strategies under extreme service environments.

Keywords Plus: HIGH-PERFORMANCE LUBRICANTS,FORMED IONIC LIQUIDS,STEEL/STEEL CONTACTS,ALLOYS,OIL
Published in CHEMICAL ENGINEERING JOURNAL,Volume549;10.1016/j.cej.2026.182378,DEC 1 2026


